Hi, When running the aarch64 Workstation, Server, and Minimal images I am not able to see the initial setup wizard. I can see the messages shown during boot but after some time the screen either starts to flicker or just blanks out. I tried this on 3 different raspberry Pis with different cards and the result is always the same. The steps I followed are 1. I downloaded the aarch64 images from [ https://fedoraproject.org/wiki/Architectures/ARM/Raspberry_Pi#Raspberry_Pi_3_aarch64_support ] and followed the instructions mentioned on the same web page to prepare the images using xzcat. 2. I connect the HDMI cable of my monitor, and connect the keyboard and mouse. I am not connecting an Ethernet cable. 3. I can see the boot screen, and the messages showing that the device is booting. 4. After some time the screen either blanks out or starts to flicker. I have tried it with different monitors and different power supplies as well but the result is the same. I noticed that the red LED of the Raspberry Pi also starts to blink abruptly. I am able to use Raspbian and OpenSuse using the same Raspberry Pis so I doubt there is an issue with the card, the power supply, or with the Pis. It would be nice if someone suggests the things I need to do, or if someone was able to troubleshoot similar issues. Regards, Ashwin _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx
