On Tue, Oct 25, 2016 at 1:12 PM, antonio montagnani <antonio.montagnani@xxxxxxxxx> wrote: > I could set the screen resolution to correct resolution. The option is available only when some devices are connected. Was that with the new kernel? > Tnx for help. > > I started Firefox, DNF (Yumex) and a terminal in Gnome, but system froze, I tried to connect by sshd, but no connection was available. I had to reset by hard reboot.... It's only got 1Gb of RAM (some of which is used by the 3D driver) and slow I/O so be aware it's not going to be the fastest at this and it might run out of memory. Just remember it's a $35 device not a fast x86 laptop. > In another session using LXDE, DNF froze the system, and also setting froze the system... On the 4 devices I have running (2 Pi3, 2 Pi2) a mix of minimal, Workstation and XFCE they all run it "OK", it's by no means fast, I tend to run dnf remotely via ssh in a screen session. Peter _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx