On Fri, Aug 21, 2015 at 3:26 AM, <dbatzle@xxxxxxxxxxxx> wrote: > I was wondering if I could get the source and configuration files that are > used to build u-boot for Fedora on ARM. It's all in the Fedora package repository for uboot-tools. "fedpkg clone uboot-tools; cd uboot-tools; fedpkg prep" will get you a fully patched tree. > I have a Pandaboard ES. Fedora 21 runs fine on it. Fedora 22 will not boot > out of the box. U-boot loads omap4-panda.dtb instead of omap4-panda-es.dtb. > If I rename the es dtb file the kernel still hangs, it just runs longer > before it hangs. Yes, it's a problem even with vanilla upstream. I see it on my Panda-ES too but just ran out of time to get to the bottom of the problem with it. I did report it upstream [1] but never got a response but I suspect there's some issue in the board/ti/panda/panda.c which might not be setting up the board specifics You can interrupt the boot and run the command "setenv fdtfile omap4-panda-es.dtb" and then just run "boot" and it'll have the correct .dtb set and it might get you further and might help you debug. [1] http://lists.denx.de/pipermail/u-boot/2015-July/219376.html > I have successfully booted 22 by using u-boot 2014.10 from Fedora 21. > > I have u-boot source from git.denx.de and have applied patches from rcn-ee > but the resulting u-boot does not work on the Fedora /boot image. > > I suppose I could wait for Fedora 23 but I would like to dig into this a > more. You could test the 2015.04 rc1 in F-24 on F-22 and see if it's fixed it, I've been traveling and not had time to look at it closer. Peter _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
