Hi team,
I am planning to test Fedora 23 ARM on Beagle Bone black from the early
image. So I downloaded Fedora-Xfce-armhfp-23-20150715-sda.raw.xz from
http://koji.fedoraproject.org/koji/taskinfo?taskID=10371084 and flash it
into a TF card.
During the flashing, I find such error:
= Writing image complete!
= Writing MLO for beaglebone....
dd: failed to open ‘/tmp/root/usr/share/uboot/beaglebone/MLO’: No such
file or directory
= Writing u-boot.img for beaglebone....
dd: failed to open ‘/tmp/root/usr/share/uboot/beaglebone/u-boot.img’: No
such file or directory
= Installation Complete! Insert into the beaglebone and boot.
$
And then I just try to boot Beagle Bone Black from the image and find it
do not work. The serial output is as following:
U-Boot SPL 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54)
reading args
spl_load_image_fat_os: error reading image args, err - -1
reading u-boot.img
reading u-boot.img
U-Boot 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54)
I2C: ready
DRAM: 512 MiB
NAND: 0 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment
Net: <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot: 0
gpio: pin 53 (gpio 53) value is 1
mmc0 is current device
gpio: pin 54 (gpio 54) value is 1
SD/MMC found on device 0
** File not found uEnv.txt **
Checking if uenvcmd is set ...
uenvcmd was not defined in uEnv.txt ...
gpio: pin 56 (gpio 56) value is 0
gpio: pin 55 (gpio 55) value is 0
gpio: pin 54 (gpio 54) value is 0
mmc1(part 0) is current device
then it boot to my system on emmc. So am I wrong in some steps? Or the
image just can not boot up on Beagle Bone Black by design?
Thanks.
--
Zamir SUN
zsun@xxxxxxxxxxxxxxxxx
zsun in #fedora-zh #openshift on freenode.net
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
