On Fri, Jul 3, 2015 at 5:30 PM, Steven Falco <stevenfalco@xxxxxxxxx> wrote: > On 07/03/2015 11:27 AM, Steven Falco wrote: >> On 07/03/2015 10:06 AM, Peter Robinson wrote: >>> On Fri, Jul 3, 2015 at 2:55 PM, Steven Falco <stevenfalco@xxxxxxxxx> wrote: >>>> I have one of the iMX6 based Utilite units. This unit is apparently >>>> not currently supported by Fedora. >>>> >>>> Are there plans to support it? If so, is there anything I can do to >>>> help? >>> >>> Which model? We do sort of support the Pro version but the upstream DT >>> support isn't great. I have some patches that improve that but I need >>> to test them. I actually updated the u-boot support for it in the >>> latest rawhide build to look at it again. >> >> I have the Pro. I'd be happy to test your patches. >> >> I'll grab a copy of rawhide from koji and give it a try. > > I downloaded Fedora-Minimal-armhfp-rawhide-20150703-sda.raw.xz > and wrote it to a uSD card. > > I am a bit unsure of how to install u-boot into the image, > but I found some instructions at https://github.com/oneru/utilite > that looked promising. > > The steps I used (where /dev/sdf is the uSD card): > > dd if=/dev/zero count=500 bs=1K | tr '\000' '\377' > cm-fx6-firmware > dd if=SPL of=cm-fx6-firmware bs=1K seek=1 conv=notrunc > dd if=u-boot.img of=cm-fx6-firmware bs=1K seek=64 conv=notrunc > dd if=cm-fx6-firmware of=/dev/sdf bs=1K skip=1 seek=1 oflag=dsync > > That does boot into u-boot, but the boot sequence hangs before > u-boot prints its command prompt. Here is what I get: > > U-Boot SPL 2015.07-rc3 (Jul 03 2015 - 01:16:44) > Booting from MMC > > > U-Boot 2015.07-rc3 (Jul 03 2015 - 01:16:44 +0000) > > CPU: Freescale i.MX6Q rev1.2 1200 MHz (running at 792 MHz) > Reset cause: POR > Board: CM-FX6 > I2C: ready > DRAM: 2 GiB > NAND: 0 MiB > MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 > SF: Detected SST25VF016B with page size 256 Bytes, erase size 4 KiB, total 2 MiB > auto-detected panel HDMI > Display: HDMI (1024x768) > > I also see a very garbled Fedora logo on the HDMI output. > > Did I use the correct commands to install u-boot onto the uSD? Grab the latest rawhide fedora-arm-installer and that should have the Utilite as an option to flash. It's called cm_fx6 _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
