Thanks! Craig On Sat, 2015-02-07 at 09:33 +0100, Hans de Goede wrote: > Hi, > > On 02/07/2015 12:32 AM, Craig Lanning wrote: > > Does Rawhide have any code to deal with the LDC panel for Olimex boards > > (Allwinner A10s CPU)? > > > > I thought I saw somewhere that it has some early support for the LCD > > panel. > > > > I downloaded the Xfce rawhide image (in hopes that it would use the > > LCD), wrote it to an SD card, installed the uboot image, and booted it. > > > > It started running through its boot messages on the console. Asked me > > the Setup questions. Finally it continued to a login prompt on the > > console. I logged in and can use the console. I looked through the > > output from "dmesg" but didn't see anything about the LCD. > > > > I have a 7 inch LCD (800x480) and an HDMI port that I could hook to an > > HD monitor (1920x1080). I am glad that even though I used a "graphical" > > image, when it didn't find a display device, it used the console. > > > > Was I mistaken about it doing anything with the LCD panel, or is there > > some additional configuration that I need to do for it to work? > > > > If it doesn't support the LCD, does it support the HDMI port? > > Rawhide as of today supports the hdmi port with 1024x768, once > rawhide gets u-boot v2015.04-rc1 it will also support EDID and use > your monitors native resolution. > > The LCD will work, but you need to build your own u-boot: > > dnf install gcc-arm-linux-gnu > git clone https://github.com/jwrdegoede/u-boot-sunxi.git > cd u-boot-sunxi > git checkout -B sunxi-wip origin/sunxi-wip > > Then edit configs/A10s-OLinuXino-M_defconfig and configs/A13-OLinuXino_defconfig > in the latter you will find a number of CONFIG_VIDEO_LCD_... lines in there, > copy those over to the configs/A10s-OLinuXino-M_defconfig file. > > Then replace CONFIG_VIDEO_LCD_POWER="AXP0-0" with > CONFIG_VIDEO_LCD_POWER="PB9" > > And then do the following to build / install: > > make -j4 CROSS_COMPILE=arm-linux-gnu- A10s-OLinuXino-M_defconfig > make -j4 CROSS_COMPILE=arm-linux-gnu- > sudo dd if=u-boot-sunxi-with-spl.bin of=/dev/mmcblk0 bs=1024 seek=8 > > You will also need an updated dtb, I've attached it for you, simply > drop the .dtb file into the dtb-3.... dir on the boot partition. > > After this u-boot should light up the lcd showin the u-boot tux > on gray waterdrop background and some boot messages, and the kernel > should take over the lcd framebuffer. > > Regards, > > Hans > _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
