On 08/04/2014 08:37 PM, Sid Boyce wrote:
On 04/08/14 20:42, Robert Moskowitz wrote:
On 08/04/2014 02:47 PM, Niels de Vos wrote:
On Mon, Aug 04, 2014 at 01:49:03PM -0400, Robert Moskowitz wrote:
I am getting far enough into my system build that I don't want to go
back to square one everytime I mess up. So I decided I SHOULD be
able to clone my boot drive with:
sudo dd if=/dev/sdb of=/dev/sdc bs=4096 conv=notrunc,noerror; sync
And I did check that my working card is in sdb and the target is
sdc. Note that the target drive has been used for prior testing.
But this cloned card fails to boot, so there is something wrong with
the above command. Here is the end of what I am seeing on the
console in the boot:
...
[ 13.911063] systemd-fsck[368]: _/: The filesystem size (according
to the superblock) is 3587707 blocks
[ OK ] Started dracut pre-mount hook.
[ 13.919598] systemd-fsck[368]: The physical size of the device is
3548795 blocks
[ 13.937109] systemd-fsck[368]: Either the superblock or the
partition table is likely to be corrupt!
...
[ 14.571964] EXT4-fs (mmcblk0p3): bad geometry: block count
3587707 exceeds size of device (3548795 blocks)
[FAILED] Failed to mount /sysroot.
During boot, is is detected that the size of the filesystem (stored in
the filesystems meta-data) is larger than the partition where it is
located. This suggests that the 'clone' is written to a smaller sd-card
than the original.
You might be able to 'fix' your working card, by resizing the
filesystem
of the 3rd partition. In the system where you do the 'dd', the
partition
would be '/dev/sdb3' and the commands you can use are 'resize2fs' or
'parted'.
# parted -l
..........
Error: Can't have a partition outside the disk!
Model: Generic- Multi-Card (scsi)
Disk /dev/sdb: 15.6GB
Sector size (logical/physical): 512B/512B
Partition Table: unknown
Disk Flags:
# resize2fs /dev/sdb3
resize2fs 1.42.8 (20-Jun-2013)
Please run 'e2fsck -f /dev/sdb3' first.
So not there yet.
See 'systemctl status sysroot.mount' for details.
[DEPEND] Dependency failed for Initrd Root File System.
[DEPEND] Dependency failed for Reload Configuration from the Real
Root.
[ OK ] Stopped dracut pre-pivot and cleanup hook.
[ OK ] Stopped target Initrd Default Target.
[ OK ] Stopped dracut mount hook.
[ OK ] Reached target Initrd File Systems.
[ OK ] Stopped target Basic System.
[ OK ] Stopped target System Initialization.
Starting Emergency Shel
Generating "/run/initramfs/rdsosreport.txt"
Entering emergency mode. Exit the shell to continue.
Type "journalctl" to view system logs.
You might want to save "/run/initramfs/rdsosreport.txt" to a USB
stick or /boot
after mounting them and attach it to a bug report.
:/# [ 17.458499] systemd-udevd (321) used greatest stack depth:
5248 bytes left
[ 17.497871] systemd-udevd (320) used greatest stack depth: 5020
bytes left
============================================
I see these stack messages regularly even when things are working.
I hope someone can help me with the cloning, as it will really
simplify my testing.
thanks
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
I have had problems with SD cards, e.g generating an image and using
dd to write it to another card of the same size, it has run out of space.
"dd if=/dev/zero of=/dev/sdx bs=1M count =xxxx" won't fix it.
The only way apparently is to use SDFormatter under Windows, then dd
writes the full size.
That has worked for me every time on someone else's Windows laptop as
I don't have Windows.
Well I still have a couple XP systems for family stuff. So I will have
to see if this is available for XP and how it works.
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
