On 07/31/2014 09:55 AM, Peter Robinson wrote:
On Thu, Jul 31, 2014 at 2:35 PM, Robert Moskowitz <rgm@xxxxxxxxxxxxxxx> wrote:
It took me a bit to work out issues with the serial console to get back into
testing. Those issues are for a separate list...
I can get Minimal to go through the install process and set timezone, root
password, and userid. When I go to log in I get:
Fedora release 21 (Twenty One)
Kernel 3.16.0-0.rc7.git1.1.fc21.armv7hl on an armv7l (ttyS0)
localhost login: root
Password:
[ 64.141895] cfg80211: Calling CRDA to update world regulatory domain
[ 66.257749] eth0: device MAC address c2:f5:e1:51:08:dd
[ 66.450111] No MAC Management Counters available
[ 66.712730] No MAC Management Counters available
[ 66.718353] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 68.632241] stmmaceth 1c50000.ethernet eth0: Link is Up - 100Mbps/Full -
flow control off
[ 68.649252] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Last login: Wed Dec 31 19:04:26 on ttyS0
[root@localhost ~]# ifconfig
-bash: ifconfig: command not found
[root@localhost ~]# echo $PATH
/usr/local/sbin:/usr/local/bin:/sbin:/bin:/usr/sbin:/usr/bin:/root/bin
[root@localhost ~]#
No commands work. I know the IP address this device gets assigned so I
tried pinging and ssh:
the ip command as replaced pretty much all stuff (actually around 10
years ago!) but once you get use it it is much nicer. There's a quick
start here http://andys.org.uk/bits/2010/02/24/iproute2-life-after-ifconfig/
or you can do "yum install net-tools" and get the old ones back.
Whow, I have been asleep at the switch on this one. Did not see it in
any notes, but then that is more than likely my fault. So I got a lot
of reading to do, and then figure out why no IP addresses (v4 or v6) are
getting assigned. I figure out enough of the IP command to see no
addresses. Even if there is a problem with my DHCP server, I am sending
out RA messages, so there should be a global IP address. I will dig a
bit and see if I can get addressing to come up properly.
Of course with no addressing, the address I *THOUGHT* this box took was
actually another test box that has SSH on another port, of course ssh
was not connecting. 'firewall-cmd --list-all-zones' shows that the ssh
service is allowed in; no change to default setups there.
ANd I cannot install net-tools until I get addressing working.
So at least I know I have a 'working' system to some definition of
working and I can go off and learn what has changed and how to live with
the changes.
thank you
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
