Hi,
On 03/20/2014 07:11 PM, Michal Hlavinka wrote:
> On 02/07/2014 07:22 AM, Lubomir Rintel wrote:
>> Hi all,
>>
>> I've generated Fedora 20 images for Allwinner A{10,20,...} devices using
>> Hans' scripts. It's basically a stock Xfce image with sunxi u-boot and
>> sunxi-3.4 linux kernel. Available here: [1], please read the README [2]
>> file for installation instructions. I've only tested on an A10 based
>> Cubieboard so far and I would be thankful for any feedback; reports
>> about other boards that should be supported in particular.
>>
>> [1] http://fedorapeople.org/~lkundrak/a10-images/
>> [2] http://fedorapeople.org/~lkundrak/a10-images/README
>
> Hi,
> I just got my first arm board - Phoenix A20
> http://linux-sunxi.org/Phoenix_Board
> http://www.swiftboard.org/wiki/index.php?title=%E9%A6%96%E9%A1%B5
>
> It uses Allwinner A20 SoC, but the README file for the remix image does not mention this board. Can I use it with u-boot for different A20 board?
You can try, but it usually best to use a u-boot + fex file tailored
fpr the board. You can start by following:
http://linux-sunxi.org/New_Device_howto
Then once we have the necessary info on the board, we can add a
config for it to u-boot, and then you can build your own u-boot
for it.
Regards,
Hans
p.s.
The upstream linux-sunxi mailinglist is a better place for sunxi
specific questions like these.
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
