On Fri, May 10, 2013 at 5:08 AM, David A. Marlin <dmarlin@xxxxxxxxxx> wrote: > On 05/09/2013 04:28 PM, Dennis Gilmore wrote: >> >> -----BEGIN PGP SIGNED MESSAGE----- >> Hash: SHA1 >> >> Hi all, >> >> there is a Release Candidate compose for Alpha at >> http://armpkgs.fedoraproject.org/mash/stage/19-Alpha-RC5/ >> >> there is a install tree as well as a image, the image is a minimal >> install. it has all 3 kernels installed, kernel, kernel-lpae, and >> kernel-tegra. to install to a sdcard run xzcat <image> > <sdcard> it >> does not have boot.scr setup >> >> as an example to boot on a trimslice you would put something like >> >> setenv bootargs cma=64M root=LABEL=_/ ro rhgb console=ttyS0,115200 >> ext2load mmc 0:1 5880000 vmlinuz-3.9.0-301.fc19.armv7hl.tegra >> ext2load mmc 0:1 4080000 uImage-3.9.0-301.fc19.armv7hl.tegra >> ext2load mmc 0:1 4000000 >> dtb-3.9.0-301.fc19.armv7hl.tegra/tegra20-trimslice.dtb >> bootz 4080000 5880000 4000000 >> >> in a boot.scr.in file in the first partition then run "mkimage -A arm >> - -O linux -a 0 -e 0 -T script -C none -n "Fedora Boot Script" -d >> boot.scr.in boot.scr" >> >> i have tested it on a trimslice > > > Is there any special U-Boot version requirement for Trim Slice, and if so, > what version(s)? The version with DTB as has been the case for all kernels 3.7+ > Also, will this image work for OMAP, and if so, are there any special > instructions for Panda? Not sure that it has the vfat partition so likely not. Peter _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
