On 04/18/2013 04:26 PM, Derek Atkins wrote:
On Thu, April 18, 2013 4:19 pm, Robert Moskowitz wrote:
# NOTE: substitute "usb 1:1" with "usb 0:1" on non-Plus model devices,
or try:
usb start
ext2ls usb x:1
#where x can be any integer but usually 0-3, the right number will show
a directory listing including the files uInitrd and uImage
Well no usb or ext2ls commands. I searched all over the image. I ran
updatedb, the tried locate. Nothing. Now what?
usb and ext2ls commands are "uboot" commands when you're sitting in the
uboot shell. Also, you might need a "newer" version of uboot to get ext
support.
Hi, Derek, long time no see :)
Fancy meeting you here.
I read the instructions again, and see I missed an important part:
"Depending on the model/version of the plug/uboot, additional uboot
parameters may be necessary or the existing ones could be edited. To do
that, stop the boot process during the countdown and follow the
instructions here. The Fedora 18 Kirkwood images contain an ext3
filesystem that cannot be booted directly by certain plugs (such as the
GuruPlug) at this time. Please follow the appropriate installation
instructions for your device."
So fortunately I am still getting that netconsole to interupt the boot
process and issue these commands...
I am going back to that 8Gb usb drive first. If it works, it gives me
more room to put software on the system.
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
