On 12/12/2011 11:00 AM, Peter Robinson wrote: > On Mon, Dec 12, 2011 at 3:58 PM,<omalleys@xxxxxxx> wrote: >> I received a pogoplug from J&R electronics, for 25 bucks with free >> shipping (after signing up for their account. limit2 and the deal ends >> today. It is a pogoplug pink E02 iirc.) >> >> I thought it was going to have the oxnas armv6 processor in it, but it >> ships with the marvell kirkwood. It only has a usb interface and GigE, >> to get to the serial port or the jtag, you need to pull it >> apart,(there are no pins on the board for anything else). Im not sure >> the -exact- specs of it. But I think it is 2gig flash and like 256 >> ram, so not the greatest, but it might be a good test machine or >> builder for someone doing armv5 work. That's a version 2 pogoplug, specs below. http://archlinuxarm.org/platforms/armv5/pogoplug-v2-pinkgray The armv6 based ones are the Pros and V3 versions. http://archlinuxarm.org/platforms/armv6/pogoplug-provideov3 I've currently got about 4 of the V2s that I'm working to build up a small Fedora dev group on. Haven't played with the V3s yet. I've already added a serial connection one of them. I wired up a JST connector to the header and brought the lines out the back using a 3.5mm headphone jack. I then connect a USB to 3.3v UART adapter. Email me off list if you need the pin outs. > > They're basically a guruplug in drag from what I recall. > > Peter Closer to a Sheeva Plug for the V2s. -- Scott Sullivan _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
