Is this the right load address for your hardware? It's not the load
address the original boot command used from what I remember.
address the original boot command used from what I remember.
that was the out of the box address except teh default boot config on sd had no address after bootm
------
Is this kernel built for your board?
that kernel was a compile on sheevaplug kernel...was hoping it would owrk...ill recompile tonight for another config. I noticed the freescale device shipped with the kernel config provided in the boot directory...
-----
You need a kernel that is built for your board type. If your CPU is arm7
then an arm7 kernel is preferred (required?) even if you will just run
armv5tel userspace.
roger that!
then an arm7 kernel is preferred (required?) even if you will just run
armv5tel userspace.
roger that!
-------- Original Message --------
Subject: Re: Freescale boot kernel
From: Henrik Nordström <henrik@xxxxxxxxxxxxxxxxxxx>
Date: Mon, October 03, 2011 7:17 am
To: webwillow@xxxxxxxxxxxxxxxx
Cc: linuxarmcross <cross-distro@xxxxxxxxxxxxxxxx>, fedoraarm
<arm@xxxxxxxxxxxxxxxxxxxxxxx>
sön 2011-10-02 klockan 16:09 -0700 skrev webwillow@xxxxxxxxxxxxxxxx:
> ext2load mmc 0:1 0x70800000 /boot/uImage-2.6.39.3-sheevaplug; bootm
> 0x70800000
Is this the right load address for your hardware? It's not the load
address the original boot command used from what I remember.
> Notice the name on the uImage which is a kernel i compiled with a
> modified kernel built with a modied kirkwood config...
Is this kernel built for your board?
> Do i need to compile another kernel with seperate config for the
> freescale device with arm7 instead of armv5tel?
You need a kernel that is built for your board type. If your CPU is arm7
then an arm7 kernel is preferred (required?) even if you will just run
armv5tel userspace.
> also, when using the "mmc 0:1" how do i change those parameters to
> load from mmc slot 2 "big slot" instead of the small mmc slot.
Probably something like
mmc init 1
ext2load mmc 1:1 ....
Regards
Henrik
_______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
