sön 2011-10-02 klockan 16:09 -0700 skrev webwillow@xxxxxxxxxxxxxxxx: > ext2load mmc 0:1 0x70800000 /boot/uImage-2.6.39.3-sheevaplug; bootm > 0x70800000 Is this the right load address for your hardware? It's not the load address the original boot command used from what I remember. > Notice the name on the uImage which is a kernel i compiled with a > modified kernel built with a modied kirkwood config... Is this kernel built for your board? > Do i need to compile another kernel with seperate config for the > freescale device with arm7 instead of armv5tel? You need a kernel that is built for your board type. If your CPU is arm7 then an arm7 kernel is preferred (required?) even if you will just run armv5tel userspace. > also, when using the "mmc 0:1" how do i change those parameters to > load from mmc slot 2 "big slot" instead of the small mmc slot. Probably something like mmc init 1 ext2load mmc 1:1 .... Regards Henrik _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
