ill give that a try :)
thats is the default config out of the box from the factory...except for the mod i put for mmcblk1p1 as root :)
-------- Original Message --------
Subject: Re: Freescale boot kernel
From: Henrik Nordström <henrik@xxxxxxxxxxxxxxxxxxx>
Date: Sun, October 02, 2011 11:19 am
To: webwillow@xxxxxxxxxxxxxxxx
Cc: linuxarmcross <cross-distro@xxxxxxxxxxxxxxxx>, fedoraarm
<arm@xxxxxxxxxxxxxxxxxxxxxxx>, Gordan Bobic <gordan@xxxxxxxxxx>
lör 2011-10-01 klockan 23:29 -0700 skrev webwillow@xxxxxxxxxxxxxxxx:
> Can anyone provide me with a little insight to configuring a feescale
> M53 device to boot to another kernel...
Your default boot commant is not very friendly, loading the kernel from
raw blocks on the mmc controller (sd card etc).
> bootcmd_mmc=run bootargs_base bootargs_mmc; mmc read 0 ${loadaddr} 0x800 0x1800; bootm
> bootcmd=run bootcmd_mmc
I would recommend you make a new bootcmd_ext2 which uses ext2load to
load the kernel. Much easier to change kernel that way. Then change
bootcmd to refer to that one when verified working.
Regards
Henrik
_______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
