Peter Robinson wrote: > Hey All, > > I know it was discussed a while ago how the USB storage on PandaBoards > was slow, not sure what the resolution was but saw this article on LWN > that looks like our problem there for those that might not have seen > the post elsewhere and are interested. > > https://lwn.net/Articles/457145/ > I have built a kernel package for f13 and f15 using Mark's patches. They are available from the xpfa repos. http://fedoraproject.org/wiki/Architectures/Fedora_ARM_Kernels#Set_Up_the_Repository The f15 repo can be set up just like the f13 version by using f15 in the path, i.e.: sudo yum --nogpgcheck install \ http://dmarlin.fedorapeople.org/packages/FedoraArm/RPMS/noarch/xpfa-15-1.noarch.rpm If you install (or update) and configure the f15 grubby (grubby-7.0.16-5.01.fc15.armv7hl.rpm) it will create the U-Boot images for you (as per the instructions mentioned above). Notes: If you use grubby, be sure to configure /etc/sysconfig/uboot _before_ installing the kernel. This version of grubby has only been tested on a Panda board (omap) and on the Trim Slice (tegra). Be sure to install the correct kernel variant for your system, i.e.: sudo yum --enablerepo=xpfa install kernel-omap # for Panda sudo yum --enablerepo=xpfa install kernel-tegra # for Trim Slice d.marlin ======== > Peter > _______________________________________________ > arm mailing list > arm@xxxxxxxxxxxxxxxxxxxxxxx > https://admin.fedoraproject.org/mailman/listinfo/arm > _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
