[root@fedora-arm home]# uaputl sys_cfg_radio_ctl 0
Radio setting successful
[root@fedora-arm home]# uaputl sys_cfg_channel 5
Channel setting successful
[root@fedora-arm home]# uaputl sys_cfg_ssid "dummyssid"
SSID setting successful
[root@fedora-arm home]# uaputl sys_cfg_protocol 32
protocol setting successful
[root@fedora-arm home]# uaputl sys_cfg_cipher 8 8
cipher setting successful
[root@fedora-arm home]# uaputl sys_cfg_wpa_passphrase "dummypasswd"
WPA passphrase setting successful
[root@fedora-arm home]# uaputl bss_start
ERR:UAP_BSS_CTRL fail, result=0
ERR:Could not start BSS!
ifconfig uap0
Link encap:Ethernet HWaddr 00:24:23:1F:B1:7B
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Some uaputl <option> give ERR: not supported "blah".
any ideas?
Note: I compiled a patched kernel (based on vanilla 2.6.34.1) with full support for libertas_uap, kopied the mrvl firmware folder from the debian rootfs over to my SDHC card, copied uaputl from the debian rootfs, did modules_install firmware_install header_install and blacklisted libertas and libertas_sdio to prevent them hogging the hardware before libertas_uap comes onto the playfield.
Help is very much appreaciate. If required I can "send"(torrent or alike) the full image (~15GiB), the KernelBuild env, uImage and modules.
Thanks for any help or tipps
Regards
Bernhard
_______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
