remu kelly wrote:
> I need to implement a rate converter after dmix, means dmix will mix 3
> channels as input, and the output will be of 48KHz, but then i need to
> convert it to 96KHz output and send to HW.
Why do you think you need to do this?
> pcm.sl1{
> type hw
> card 0
> device 0
> }
>
> pcm_slave.sl2 {
> pcm sl1
> rate 96000
> }
This says that the the hardware device must run at 96 kHz.
> pcm.mix1 {
> type dmix
> ipc_key 1024
> slave sl2
> }
Because of the above, the dmix plugin also runs at 96 kHz.
Why don't you want this?
Regards,
Clemens
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Alsa-user mailing list
Alsa-user@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/alsa-user
