At Wed, 3 Sep 2014 18:13:54 +0300, Nerijus Baliunas wrote: > > On Wed, 03 Sep 2014 17:07:56 +0200 Takashi Iwai <tiwai@xxxxxxx> wrote: > > > You're setting the master volume to -24dB now while you've set it to > > -18dB in the past. The percent representation doesn't mean anything > > accurate. Just raise the master volume a bit higher to match with the > > right dB level (which can be seen in the mixer). > > I've set now volume to 100%. The volume is much lower than on 3.14. It's because the volume was overloaded in 3.14 and earlier. It came through the mixer widget and it has the gain over 0dB. If you set 100% amp in the pin and sets more than 0dB in the mixer, it's basically more than 100%, overloading. That is, the new driver corrected the wrong volume setup. Takashi ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that matters. http://tv.slashdot.org/ _______________________________________________ Alsa-user mailing list Alsa-user@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/alsa-user
